#DIY

Test-assembly of the Tesla Coil enclosure. edit: it seems picture upload is broken ATM

had to add a NAND (the tiny black thing on the right behind the red wire) gate (wired as NOT) to the Tesla coil optical input

these 0805 size resistors are mighty handy with breadboards.

used the plasmacutter we repaired in "production" for the first time

prototype board for Micrel EL driver, uses trimmers so I can adjust the switching frequencies.

That's a lot of PCBs for 15USD

lasercut enclosure parts for the Tesla Coil (the photo is a bit poor)

Milling a straight edge to a bit of sawed aluminium (this will act as fitting adapter for fans on the heatsink of my Tesla Coil driver)

made heatsinks for the mortor driver boards I got from Pololu, here is one showing how it fits in place.